1. Unscrew the screw on the plug and remove the case.
2. Unscrew the screw on the crimping shaft, and remove the crimping shaft.
3. Loosen the screw on the terminal post.
4. Use wire strippers to strip about 5 to 10 mm of insulation from the wires.
5. Insert the stripped copper wire into the binding post. If there are more copper wires exposed, you can insert the copper wire. Fold in half and then insert the terminal to ensure that the copper wires of the two wires will not touch together and cause a short circuit.
6. Tighten the two screws on the terminal post.
7. Install the crimping shaft and tighten the screw on the crimping shaft.
8.
Put the upper plug housing and tighten the housing screws.
Precautions:
When wiring, the red wire goes into the right hole and the blue wire goes into the left hole.
After tightening the terminal screw, you should check whether the wires are tight, and check whether the copper wires of the two wires are short-circuited.
Mains electricity is dangerous, and work with live electricity is not allowed.
