Aug 23, 2022 Leave a message

Data Interface of Industrial Camera - Camera Link Interface

Data Interface of Industrial Camera - Camera Link Interface


The so-called data interface is an electrical interface used by industrial cameras to transmit image data to the host (usually an industrial computer) (in addition to the hardware interface, of course, there must be a supporting data transmission protocol specification). The camera's data interface is much more important than the lens interface! Because it directly determines the core performance indicators of this camera and its scope of application. For example, if you want to deploy surveillance cameras over long distances, then the network interface is a more suitable solution; if you want to use high frame rate and high resolution cameras, but the transmission distance is not far, then the CoaXPress or Camera Link interface should be taken into consideration.


The data interface of industrial cameras can be divided into two categories: "digital interface" and "analog interface". The former transmits a digital signal, the latter an analog signal. Compared with analog signals, digital signals have many advantages, such as strong anti-interference ability, easy encryption, and easy subsequent processing. Therefore, the existing high-end industrial cameras all use digital interfaces without exception. Of course, the analog interface also has its own advantages (mainly cheap and cost-effective). It is common in low-end monitoring equipment and will not be eliminated in a short time.


The digital interfaces of industrial cameras mainly include the following categories: Camera Link interface, IEEE 1394 interface, USB interface, network interface, CoaXPress interface. This article focuses on the Camera Link interface


As can be seen from the name of the Camera Link interface, this interface is specially developed for the special application requirements of industrial cameras (large amount of image data and high bandwidth requirements), so its transmission speed must be relatively high. Fast, this is one of the main advantages of the Camera Link interface.


For cameras using the Camera Link interface, it needs to be used with the Camera Link capture card. The Camera Link capture card is generally installed on the control computer through the PCI-E interface (for earlier capture cards, the low-end models used the PCI interface. , high-end model PCI-X interface)


In addition, the Camera Link interface is divided into "big mouth" (MDR) and "small mouth" (SDR, or HDR-mini). The pin definitions of the two are exactly the same, but the size is different.


Why make a "small mouth", because the regular Camera Link interface is indeed a bit too big. Especially for some high-speed cameras, it may need to use four interfaces to meet the bandwidth requirements. At this time, if the interface is too large, the volume of the camera should also be relatively large, which is obviously a bit inconvenient.


Note:


The Camera Link interface does not support hot swapping. When the camera is working with power on, it is strictly forbidden to unplug the data interface, which may damage the camera.


Camera Link Cable PoCL Mini to Standard High Flex


Send Inquiry

whatsapp

Phone

E-mail

Inquiry